Monday, August 19, 2019

Monday, August 19 2019 - Fluke DMM class, Measuring Resistance, Voltage and Current

Setup Classroom Technology ( Infinite Campus) 
FLUKE DMM Class
  • Assignment - Sign up for this FLUKE DMM class
  • Duration: 15 Min
  • Instructions & Expectations: Sign up for this FLUKE DMM training class.  It's about 2 hours of video training on how to use a Digital Multi Meter. 
  • How to Submit Assignment: Go to our Mechatronics Engineering google classroom and check the STREAM for the training assignment and submit a screen shot of the completed class. - 200 Points Due Monday Aug 26 - Minus 20 points every day after that...

Mechatronics Engineering Plan For Today:
  • Entry Ticket 
  • Looking at the Mechatronics Google Site
  • Multi Meter Lab
  • Open Lab - Printer Tear Down
  • Clean Up


Mechatronics Engineering Google Site 

Digital Multi Meter Lab (Intro To Resistors)

Printers
  • LAB - Duration: 30 Min
  • Instructions & Expectations: Have fun tearing down printers... but also sketch some interesting engineering / manufacturing design that the printers took advantage of.  Keep wires connected to motors and sensors... don't just cut them.  If you have to cut, cut as far away from the motor or sensor connection as you can.
  • How to Submit Assignment:   Take notes and Draw in your Interactive Engineering Note Book.  I will grade this over the week end.
Clean Up
  • Assignment - Duration: 2-10 Min
  • Instructions & Expectations: Desk cleanup, put away all projects, find your assigned job
  • How to Submit Assignment: When Complete, check yourself off on Sign Out Sheet - 10 Points

No comments:

Post a Comment