Mechatronics Engineering Google Site
Special Instructions:
Entry Ticket - Writing is Re-Writing
- Assignment - Duration: 10 Min
- Link: Writing is Re-Writing
- Instructions & Expectations: Check out this Professional Development link on Writing Skill. Be ready to Discuss
- Dig Deeper: Click on the links at the end of the page linked above
Mechatronics Engineering Plan For Today:
|
|
Capacitor Introduction
- Lecture/Presentation/Lab - Duration: 60 Min
- Link:
- Learn how to chart data - https://support.google.com/docs/answer/63824?co=GENIE.Platform%3DDesktop&hl=en
- https://learn.sparkfun.com/tutorials/capacitors
- http://physics.bu.edu/~duffy/HTML5/RC_circuit.html
- https://www.falstad.com/circuit/
- Instructions & Expectations: Listen and take notes in your Interactive Lab Book. If needed review the posted slide presentation. Collect a table of data, and then chart it. Use the template found here in the Mechatronics Engineering google classroom and check the STREAM for current Capacitor assignment. Take a statistical relevant data points... What is that? Maybe every 1 sec, maybe every 10 sec... measure the voltage rise between 0v and 5v and then again from 5v to 0v. You should have 15-30 data points for the charging data and the same number for the discharge data
Jeopardy Controller https://docs.google.com/document/d/1fRWk6BnRJ4prfo8S32wCumodbKldp6J6bFbFtSrfTW8/edit?usp=sharing
- Show me Your Code Running On My Simulator
Open LAB and/or Robot Club
- LAB - Duration: 60 Min
- Link: Robot Club Google Sites
- Instructions & Expectations: Connect with your Robot Club Team. You will either be working on your Robot Project or an Open Lab Project.
- You will need to account for your time. You will need to convince me by your form submission that you worked given the time allotted.
- If you or your Robot Club Team worked on the Robot Club project, you will make sure your Robot Project Status Google docs are updated.
- If you worked on an Open Lab Project, you will also need to tell me about what you accomplished and what you are planning next.
- How to Submit Assignment: Each Student needs to account for your time.
- Every One Do The Following: Turn in an Open Lab Blog Post
- If you also worked on your Robot Club Project, also UPDATE your Robot Project Status Google docs.
- Dig Deeper: Open Lab:
- Robot Club Google Sites
- Guest LED Lesson
- Printers - Work on taking the printers apart
- TinkerCAD
- Udemy - My Courses (specifically the Arduino Workshop and Electronics Engineering Technology class)
- Assignment - Duration: 2-10 Min
- Instructions & Expectations: Desk cleanup, put away all projects, find your assigned job
- How to Submit Assignment: When Complete, check yourself off on Sign Out Sheet - 2 Points
No comments:
Post a Comment